A certificate of analysis (COA) is the document a laboratory issues to report what was measured in a specific batch of material. For research peptides, it is the main way a buyer can check identity, purity and handling information before a vial goes into an experiment. This guide explains the sections you will usually find and what to look for. All products discussed are for laboratory research use only, not for human or veterinary use.
1. Batch or lot number
The COA must name the batch it describes. Match the lot number on the document to the lot number on your vial. A COA without a lot number, or with one that does not match, tells you nothing about the material you received.
2. Testing laboratory and date
Look for the name of the laboratory that ran the tests and the date the results were reported. A third-party laboratory is a stronger signal than an in-house report, because the tester has no stake in the result.
3. Identity by mass spectrometry
Mass spectrometry (MS) measures the molecular mass of the compound. The reported mass should agree with the theoretical mass for that peptide. Identity by MS answers the question "is this the right molecule?", which is separate from purity.
4. Purity by HPLC
High-performance liquid chromatography (HPLC) separates the components of a sample, and the main peak area is reported as a percentage of the total peak area. Check the detection wavelength (peptides are commonly read near 214 to 220 nm), the method or column named, and whether a chromatogram is attached so you can see the main peak and any impurity peaks. A purity percentage with no chromatogram is a claim, not evidence.
5. Net peptide content
Purity and net peptide content are different numbers. A lyophilized vial contains peptide plus counter-ions such as acetate or trifluoroacetate and residual water. Net peptide content states how much of the vial contents is actual peptide, so a nominal 10 mg vial can contain less than 10 mg of peptide. When a COA reports it, use that figure when you calculate molar amounts.
6. Appearance, solubility and storage
COAs often note appearance (for example white to off-white lyophilized powder), solubility and recommended storage. Lyophilized peptides are generally stored sealed at -20 C, protected from light and moisture. Follow the storage conditions stated for your specific product.
7. Red flags
- No lot number, no laboratory name or no date.
- A purity figure but no chromatogram or method.
- A COA that looks like a generic template reused across different products.
- Identity claimed without a mass-spectrometry result.
- A document that does not match the product label.
Checklist before you use a vial
- Does the lot number match your vial?
- Was the test run by a named laboratory, and when?
- Is identity confirmed by MS against the theoretical mass?
- Is the HPLC chromatogram attached, with the method stated?
- Is net peptide content reported, and have you used it in your calculations?
Where to find our documentation
Batch documentation is listed on our Lab Results page as it becomes available for each product, and our full range is on the research peptides collection. If you need the COA for a specific lot, contact us with the lot number.
Research-use notice: products sold by Peptide Biogenix are laboratory reagents for in-vitro research only. They are not drugs, foods, supplements or cosmetics, have not been evaluated by the FDA, and must not be administered to humans or animals. This article is educational and is not medical or legal advice.
